mirror of
https://github.com/torvalds/linux.git
synced 2024-11-17 17:41:44 +00:00
10f4338ca8
The setup-bus code doesn't work correctly for configurations with more than one display adapter in the same PCI domain. This stuff actually is a leftover of an early 2.4 PCI setup code and apparently it stopped working after some "bridge_ctl" changes. So the best thing we can do is just to remove it and rely on the fact that any firmware *has* to configure VGA port forwarding for the boot display device properly. But then we need to ensure that the bus->bridge_ctl will always contain valid information collected at the probe time, therefore the following change in pci_scan_bridge() is needed. Signed-off-by: Ivan Kokshaysky <ink@jurassic.park.msu.ru> Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de> Signed-off-by: Linus Torvalds <torvalds@osdl.org> |
||
|---|---|---|
| .. | ||
| hotplug | ||
| pcie | ||
| access.c | ||
| bus.c | ||
| gen-devlist.c | ||
| hotplug.c | ||
| Kconfig | ||
| Makefile | ||
| msi.c | ||
| msi.h | ||
| names.c | ||
| pci-acpi.c | ||
| pci-driver.c | ||
| pci-sysfs.c | ||
| pci.c | ||
| pci.h | ||
| pci.ids | ||
| probe.c | ||
| proc.c | ||
| quirks.c | ||
| remove.c | ||
| rom.c | ||
| search.c | ||
| setup-bus.c | ||
| setup-irq.c | ||
| setup-res.c | ||
| syscall.c | ||