mirror of
https://github.com/torvalds/linux.git
synced 2024-11-10 14:11:52 +00:00
3c89a068bf
s2idle works like a regular suspend with freezing processes and freezing devices. All CPUs except the control CPU go into idle. Once this is completed the control CPU kicks all other CPUs out of idle, so that they reenter the idle loop and then enter s2idle state. The control CPU then issues an swait() on the suspend state and therefore enters the idle loop as well. Due to being kicked out of idle, the other CPUs leave their NOHZ states, which means the tick is active and the corresponding hrtimer is programmed to the next jiffie. On entering s2idle the CPUs shut down their local clockevent device to prevent wakeups. The last CPU which enters s2idle shuts down its local clockevent and freezes timekeeping. On resume, one of the CPUs receives the wakeup interrupt, unfreezes timekeeping and its local clockevent and starts the resume process. At that point all other CPUs are still in s2idle with their clockevents switched off. They only resume when they are kicked by another CPU or after resuming devices and then receiving a device interrupt. That means there is no guarantee that all CPUs will wakeup directly on resume. As a consequence there is no guarantee that timers which are queued on those CPUs and should expire directly after resume, are handled. Also timer list timers which are remotely queued to one of those CPUs after resume will not result in a reprogramming IPI as the tick is active. Queueing a hrtimer will also not result in a reprogramming IPI because the first hrtimer event is already in the past. The recent introduction of the timer pull model ( |
||
|---|---|---|
| .. | ||
| autosleep.c | ||
| console.c | ||
| energy_model.c | ||
| hibernate.c | ||
| Kconfig | ||
| main.c | ||
| Makefile | ||
| power.h | ||
| poweroff.c | ||
| process.c | ||
| qos.c | ||
| snapshot.c | ||
| suspend_test.c | ||
| suspend.c | ||
| swap.c | ||
| user.c | ||
| wakelock.c | ||