mirror of
https://github.com/torvalds/linux.git
synced 2024-11-16 09:02:00 +00:00
87f40dd6ce
QFQ+ inherits from QFQ a design choice that may cause a high packet delay/jitter and a severe short-term unfairness. As QFQ, QFQ+ uses a special quantity, the system virtual time, to track the service provided by the ideal system it approximates. When a packet is dequeued, this quantity must be incremented by the size of the packet, divided by the sum of the weights of the aggregates waiting to be served. Tracking this sum correctly is a non-trivial task, because, to preserve tight service guarantees, the decrement of this sum must be delayed in a special way [1]: this sum can be decremented only after that its value would decrease also in the ideal system approximated by QFQ+. For efficiency, QFQ+ keeps track only of the 'instantaneous' weight sum, increased and decreased immediately as the weight of an aggregate changes, and as an aggregate is created or destroyed (which, in its turn, happens as a consequence of some class being created/destroyed/changed). However, to avoid the problems caused to service guarantees by these immediate decreases, QFQ+ increments the system virtual time using the maximum value allowed for the weight sum, 2^10, in place of the dynamic, instantaneous value. The instantaneous value of the weight sum is used only to check whether a request of weight increase or a class creation can be satisfied. Unfortunately, the problems caused by this choice are worse than the temporary degradation of the service guarantees that may occur, when a class is changed or destroyed, if the instantaneous value of the weight sum was used to update the system virtual time. In fact, the fraction of the link bandwidth guaranteed by QFQ+ to each aggregate is equal to the ratio between the weight of the aggregate and the sum of the weights of the competing aggregates. The packet delay guaranteed to the aggregate is instead inversely proportional to the guaranteed bandwidth. By using the maximum possible value, and not the actual value of the weight sum, QFQ+ provides each aggregate with the worst possible service guarantees, and not with service guarantees related to the actual set of competing aggregates. To see the consequences of this fact, consider the following simple example. Suppose that only the following aggregates are backlogged, i.e., that only the classes in the following aggregates have packets to transmit: one aggregate with weight 10, say A, and ten aggregates with weight 1, say B1, B2, ..., B10. In particular, suppose that these aggregates are always backlogged. Given the weight distribution, the smoothest and fairest service order would be: A B1 A B2 A B3 A B4 A B5 A B6 A B7 A B8 A B9 A B10 A B1 A B2 ... QFQ+ would provide exactly this optimal service if it used the actual value for the weight sum instead of the maximum possible value, i.e., 11 instead of 2^10. In contrast, since QFQ+ uses the latter value, it serves aggregates as follows (easy to prove and to reproduce experimentally): A B1 B2 B3 B4 B5 B6 B7 B8 B9 B10 A A A A A A A A A A B1 B2 ... B10 A A ... By replacing 10 with N in the above example, and by increasing N, one can increase at will the maximum packet delay and the jitter experienced by the classes in aggregate A. This patch addresses this issue by just using the above 'instantaneous' value of the weight sum, instead of the maximum possible value, when updating the system virtual time. After the instantaneous weight sum is decreased, QFQ+ may deviate from the ideal service for a time interval in the order of the time to serve one maximum-size packet for each backlogged class. The worst-case extent of the deviation exhibited by QFQ+ during this time interval [1] is basically the same as of the deviation described above (but, without this patch, QFQ+ suffers from such a deviation all the time). Finally, this patch modifies the comment to the function qfq_slot_insert, to make it coherent with the fact that the weight sum used by QFQ+ can now be lower than the maximum possible value. [1] P. Valente, "Extending WF2Q+ to support a dynamic traffic mix", Proceedings of AAA-IDEA'05, June 2005. Signed-off-by: Paolo Valente <paolo.valente@unimore.it> Signed-off-by: David S. Miller <davem@davemloft.net> |
||
|---|---|---|
| .. | ||
| act_api.c | ||
| act_csum.c | ||
| act_gact.c | ||
| act_ipt.c | ||
| act_mirred.c | ||
| act_nat.c | ||
| act_pedit.c | ||
| act_police.c | ||
| act_simple.c | ||
| act_skbedit.c | ||
| cls_api.c | ||
| cls_basic.c | ||
| cls_cgroup.c | ||
| cls_flow.c | ||
| cls_fw.c | ||
| cls_route.c | ||
| cls_rsvp6.c | ||
| cls_rsvp.c | ||
| cls_rsvp.h | ||
| cls_tcindex.c | ||
| cls_u32.c | ||
| em_canid.c | ||
| em_cmp.c | ||
| em_ipset.c | ||
| em_meta.c | ||
| em_nbyte.c | ||
| em_text.c | ||
| em_u32.c | ||
| ematch.c | ||
| Kconfig | ||
| Makefile | ||
| sch_api.c | ||
| sch_atm.c | ||
| sch_blackhole.c | ||
| sch_cbq.c | ||
| sch_choke.c | ||
| sch_codel.c | ||
| sch_drr.c | ||
| sch_dsmark.c | ||
| sch_fifo.c | ||
| sch_fq_codel.c | ||
| sch_generic.c | ||
| sch_gred.c | ||
| sch_hfsc.c | ||
| sch_htb.c | ||
| sch_ingress.c | ||
| sch_mq.c | ||
| sch_mqprio.c | ||
| sch_multiq.c | ||
| sch_netem.c | ||
| sch_plug.c | ||
| sch_prio.c | ||
| sch_qfq.c | ||
| sch_red.c | ||
| sch_sfb.c | ||
| sch_sfq.c | ||
| sch_tbf.c | ||
| sch_teql.c | ||