mirror of
https://github.com/torvalds/linux.git
synced 2024-11-10 22:21:40 +00:00
6a7c3e464e
The UWB stack has some sysfs APIs that will change thus it's best marked as EXPERIMENTAL until these APIs are finalized. Signed-off-by: David Vrabel <david.vrabel@csr.com>
91 lines
3.1 KiB
Plaintext
91 lines
3.1 KiB
Plaintext
#
|
|
# UWB device configuration
|
|
#
|
|
|
|
menuconfig UWB
|
|
tristate "Ultra Wideband devices (EXPERIMENTAL)"
|
|
depends on EXPERIMENTAL
|
|
depends on PCI
|
|
default n
|
|
help
|
|
UWB is a high-bandwidth, low-power, point-to-point radio
|
|
technology using a wide spectrum (3.1-10.6GHz). It is
|
|
optimized for in-room use (480Mbps at 2 meters, 110Mbps at
|
|
10m). It serves as the transport layer for other protocols,
|
|
such as Wireless USB (WUSB), IP (WLP) and upcoming
|
|
Bluetooth and 1394
|
|
|
|
The topology is peer to peer; however, higher level
|
|
protocols (such as WUSB) might impose a master/slave
|
|
relationship.
|
|
|
|
Say Y here if your computer has UWB radio controllers (USB or PCI)
|
|
based. You will need to enable the radio controllers
|
|
below. It is ok to select all of them, no harm done.
|
|
|
|
For more help check the UWB and WUSB related files in
|
|
<file:Documentation/usb/>.
|
|
|
|
To compile the UWB stack as a module, choose M here.
|
|
|
|
if UWB
|
|
|
|
config UWB_HWA
|
|
tristate "UWB Radio Control driver for WUSB-compliant USB dongles (HWA)"
|
|
depends on USB
|
|
help
|
|
This driver enables the radio controller for HWA USB
|
|
devices. HWA stands for Host Wire Adapter, and it is a UWB
|
|
Radio Controller connected to your system via USB. Most of
|
|
them come with a Wireless USB host controller also.
|
|
|
|
To compile this driver select Y (built in) or M (module). It
|
|
is safe to select any even if you do not have the hardware.
|
|
|
|
config UWB_WHCI
|
|
tristate "UWB Radio Control driver for WHCI-compliant cards"
|
|
depends on PCI
|
|
help
|
|
This driver enables the radio controller for WHCI cards.
|
|
|
|
WHCI is an specification developed by Intel
|
|
(http://www.intel.com/technology/comms/wusb/whci.htm) much
|
|
in the spirit of USB's EHCI, but for UWB and Wireless USB
|
|
radio/host controllers connected via memmory mapping (eg:
|
|
PCI). Most of these cards come also with a Wireless USB host
|
|
controller.
|
|
|
|
To compile this driver select Y (built in) or M (module). It
|
|
is safe to select any even if you do not have the hardware.
|
|
|
|
config UWB_WLP
|
|
tristate "Support WiMedia Link Protocol (Ethernet/IP over UWB)"
|
|
depends on UWB && NET
|
|
help
|
|
This is a common library for drivers that implement
|
|
networking over UWB.
|
|
|
|
config UWB_I1480U
|
|
tristate "Support for Intel Wireless UWB Link 1480 HWA"
|
|
depends on UWB_HWA
|
|
select FW_LOADER
|
|
help
|
|
This driver enables support for the i1480 when connected via
|
|
USB. It consists of a firmware uploader that will enable it
|
|
to behave as an HWA device.
|
|
|
|
To compile this driver select Y (built in) or M (module). It
|
|
is safe to select any even if you do not have the hardware.
|
|
|
|
config UWB_I1480U_WLP
|
|
tristate "Support for Intel Wireless UWB Link 1480 HWA's WLP interface"
|
|
depends on UWB_I1480U && UWB_WLP && NET
|
|
help
|
|
This driver enables WLP support for the i1480 when connected via
|
|
USB. WLP is the WiMedia Link Protocol, or IP over UWB.
|
|
|
|
To compile this driver select Y (built in) or M (module). It
|
|
is safe to select any even if you don't have the hardware.
|
|
|
|
endif # UWB
|