mirror of
https://github.com/torvalds/linux.git
synced 2024-11-15 00:21:59 +00:00
5fdd4baef6
When retransmitting due to T3 timeout, retransmit all the in-flight chunks for the corresponding transport/path, including chunks sent less then 1 rto ago. This is the correct behaviour according to rfc4960 section 6.3.3 E3 and "Note: Any DATA chunks that were sent to the address for which the T3-rtx timer expired but did not fit in one MTU (rule E3 above) should be marked for retransmission and sent as soon as cwnd allows (normally, when a SACK arrives). ". This fixes problems when more then one path is present and the T3 retransmission of the first chunk that timeouts stops the T3 timer for the initial active path, leaving all the other in-flight chunks waiting forever or until a new chunk is transmitted on the same path and timeouts (and this will happen only if the cwnd allows sending new chunks, but since cwnd was dropped to MTU by the timeout => it will wait until the first heartbeat). Example: 10 packets in flight, sent at 0.1 s intervals on the primary path. The primary path is down and the first packet timeouts. The first packet is retransmitted on another path, the T3 timer for the primary path is stopped and cwnd is set to MTU. All the other 9 in-flight packets will not be retransmitted (unless more new packets are sent on the primary path which depend on cwnd allowing it, and even in this case the 9 packets will be retransmitted only after a new packet timeouts which even in the best case would be more then RTO). This commit reverts |
||
---|---|---|
.. | ||
associola.c | ||
auth.c | ||
bind_addr.c | ||
chunk.c | ||
command.c | ||
debug.c | ||
endpointola.c | ||
input.c | ||
inqueue.c | ||
ipv6.c | ||
Kconfig | ||
Makefile | ||
objcnt.c | ||
output.c | ||
outqueue.c | ||
primitive.c | ||
proc.c | ||
protocol.c | ||
sm_make_chunk.c | ||
sm_sideeffect.c | ||
sm_statefuns.c | ||
sm_statetable.c | ||
socket.c | ||
ssnmap.c | ||
sysctl.c | ||
transport.c | ||
tsnmap.c | ||
ulpevent.c | ||
ulpqueue.c |