linux/drivers/usb/musb/Makefile
Apelete Seketeli 10434d273c usb: musb: add support for JZ4740 usb device controller
Add support for Ingenic JZ4740 USB Device Controller through a
specific musb glue layer.

JZ4740 UDC not being OTG compatible and missing some hardware
registers, this musb glue layer is written from scratch to be used in
gadget mode only and take silicon design specifics into account.

Signed-off-by: Apelete Seketeli <apelete@seketeli.net>
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
Signed-off-by: Felipe Balbi <balbi@ti.com>
2013-12-20 09:53:24 -06:00

37 lines
1.3 KiB
Makefile

#
# for USB OTG silicon based on Mentor Graphics INVENTRA designs
#
obj-$(CONFIG_USB_MUSB_HDRC) += musb_hdrc.o
musb_hdrc-y := musb_core.o
musb_hdrc-$(CONFIG_USB_MUSB_HOST)$(CONFIG_USB_MUSB_DUAL_ROLE) += musb_virthub.o musb_host.o
musb_hdrc-$(CONFIG_USB_MUSB_GADGET)$(CONFIG_USB_MUSB_DUAL_ROLE) += musb_gadget_ep0.o musb_gadget.o
musb_hdrc-$(CONFIG_DEBUG_FS) += musb_debugfs.o
# Hardware Glue Layer
obj-$(CONFIG_USB_MUSB_OMAP2PLUS) += omap2430.o
obj-$(CONFIG_USB_MUSB_AM35X) += am35x.o
obj-$(CONFIG_USB_MUSB_DSPS) += musb_dsps.o
obj-$(CONFIG_USB_MUSB_TUSB6010) += tusb6010.o
obj-$(CONFIG_USB_MUSB_DAVINCI) += davinci.o
obj-$(CONFIG_USB_MUSB_DA8XX) += da8xx.o
obj-$(CONFIG_USB_MUSB_BLACKFIN) += blackfin.o
obj-$(CONFIG_USB_MUSB_UX500) += ux500.o
obj-$(CONFIG_USB_MUSB_JZ4740) += jz4740.o
obj-$(CONFIG_USB_MUSB_AM335X_CHILD) += musb_am335x.o
# the kconfig must guarantee that only one of the
# possible I/O schemes will be enabled at a time ...
# PIO only, or DMA (several potential schemes).
# though PIO is always there to back up DMA, and for ep0
musb_hdrc-$(CONFIG_USB_INVENTRA_DMA) += musbhsdma.o
musb_hdrc-$(CONFIG_USB_TI_CPPI_DMA) += cppi_dma.o
musb_hdrc-$(CONFIG_USB_TUSB_OMAP_DMA) += tusb6010_omap.o
musb_hdrc-$(CONFIG_USB_UX500_DMA) += ux500_dma.o
musb_hdrc-$(CONFIG_USB_TI_CPPI41_DMA) += musb_cppi41.o