linux/drivers/usb/musb/Makefile
Ajay Kumar Gupta 9ecb887522 usb: musb: Add support for ti81xx platform
TI81XX platform has two musb interfaces and uses CPPI4.1 DMA engine.
It has builtin USB PHYs as AM35x. The current set of patches adds support
for one instance and only in PIO mode.

[ balbi@ti.com : make it compile and solve a "may be used
	uninitialized" warning ]

Signed-off-by: Ajay Kumar Gupta <ajay.gupta@ti.com>
Signed-off-by: Ravi Babu <ravibabu@ti.com>
Signed-off-by: Felipe Balbi <balbi@ti.com>
2012-05-04 13:59:34 +03:00

32 lines
1.1 KiB
Makefile

#
# for USB OTG silicon based on Mentor Graphics INVENTRA designs
#
obj-$(CONFIG_USB_MUSB_HDRC) += musb_hdrc.o
musb_hdrc-y := musb_core.o
musb_hdrc-y += musb_gadget_ep0.o musb_gadget.o
musb_hdrc-y += musb_virthub.o musb_host.o
musb_hdrc-$(CONFIG_DEBUG_FS) += musb_debugfs.o
# Hardware Glue Layer
obj-$(CONFIG_USB_MUSB_OMAP2PLUS) += omap2430.o
obj-$(CONFIG_USB_MUSB_AM35X) += am35x.o
obj-$(CONFIG_USB_MUSB_DSPS) += musb_dsps.o
obj-$(CONFIG_USB_MUSB_TUSB6010) += tusb6010.o
obj-$(CONFIG_USB_MUSB_DAVINCI) += davinci.o
obj-$(CONFIG_USB_MUSB_DA8XX) += da8xx.o
obj-$(CONFIG_USB_MUSB_BLACKFIN) += blackfin.o
obj-$(CONFIG_USB_MUSB_UX500) += ux500.o
# the kconfig must guarantee that only one of the
# possible I/O schemes will be enabled at a time ...
# PIO only, or DMA (several potential schemes).
# though PIO is always there to back up DMA, and for ep0
musb_hdrc-$(CONFIG_USB_INVENTRA_DMA) += musbhsdma.o
musb_hdrc-$(CONFIG_USB_TI_CPPI_DMA) += cppi_dma.o
musb_hdrc-$(CONFIG_USB_TUSB_OMAP_DMA) += tusb6010_omap.o
musb_hdrc-$(CONFIG_USB_UX500_DMA) += ux500_dma.o