mirror of
https://github.com/torvalds/linux.git
synced 2024-11-15 16:41:58 +00:00
5d9ca430ea
Updated version of the ltc2990 driver which supports all measurement modes (current, voltage, temperature) available in the chip. If devicetree is used, the mode must be specified with the property "lltc,meas-mode". The format and possible values of the property are described in the binding. If devicetree is not used, the mode of the chip will not be configured. Unless the chip is configured by another source, only the internal temperature and supply voltage will be measured. Signed-off-by: Tom Levens <tom.levens@cern.ch> Tested-By: mike.looijmans@topic.nl [groeck: Fixed compiler warning] Signed-off-by: Guenter Roeck <linux@roeck-us.net>
50 lines
1.6 KiB
Plaintext
50 lines
1.6 KiB
Plaintext
Kernel driver ltc2990
|
|
=====================
|
|
|
|
Supported chips:
|
|
* Linear Technology LTC2990
|
|
Prefix: 'ltc2990'
|
|
Addresses scanned: -
|
|
Datasheet: http://www.linear.com/product/ltc2990
|
|
|
|
Author: Mike Looijmans <mike.looijmans@topic.nl>
|
|
Tom Levens <tom.levens@cern.ch>
|
|
|
|
|
|
Description
|
|
-----------
|
|
|
|
LTC2990 is a Quad I2C Voltage, Current and Temperature Monitor.
|
|
The chip's inputs can measure 4 voltages, or two inputs together (1+2 and 3+4)
|
|
can be combined to measure a differential voltage, which is typically used to
|
|
measure current through a series resistor, or a temperature with an external
|
|
diode.
|
|
|
|
|
|
Usage Notes
|
|
-----------
|
|
|
|
This driver does not probe for PMBus devices. You will have to instantiate
|
|
devices explicitly.
|
|
|
|
|
|
Sysfs attributes
|
|
----------------
|
|
|
|
in0_input Voltage at Vcc pin in millivolt (range 2.5V to 5V)
|
|
temp1_input Internal chip temperature in millidegrees Celcius
|
|
|
|
A subset of the following attributes are visible, depending on the measurement
|
|
mode of the chip.
|
|
|
|
in[1-4]_input Voltage at V[1-4] pin in millivolt
|
|
temp2_input External temperature sensor TR1 in millidegrees Celcius
|
|
temp3_input External temperature sensor TR2 in millidegrees Celcius
|
|
curr1_input Current in mA across V1-V2 assuming a 1mOhm sense resistor
|
|
curr2_input Current in mA across V3-V4 assuming a 1mOhm sense resistor
|
|
|
|
The "curr*_input" measurements actually report the voltage drop across the
|
|
input pins in microvolts. This is equivalent to the current through a 1mOhm
|
|
sense resistor. Divide the reported value by the actual sense resistor value
|
|
in mOhm to get the actual value.
|