linux/drivers/thunderbolt/Kconfig
Mika Westerberg ff6ab055e0 thunderbolt: Add receiver lane margining support for retimers
Retimers support lane margining as well so make this available through
debugfs in the same way as we do for the USB4 ports. When this is
enabled we also expose retimers on the other side of the cable because
typically margining is implemented only on direction towards the cable.
However, for the retimers on the other side of the cable we do not allow
NVM upgrade to avoid confusing the existing userspace (the same retimer
may now appear twice with different name) and is probably not a good
idea anyway.

Signed-off-by: Mika Westerberg <mika.westerberg@linux.intel.com>
2024-06-17 12:47:12 +03:00

64 lines
2.1 KiB
Plaintext

# SPDX-License-Identifier: GPL-2.0-only
menuconfig USB4
tristate "Unified support for USB4 and Thunderbolt"
depends on PCI
select APPLE_PROPERTIES if EFI_STUB && X86
select CRC32
select CRYPTO
select CRYPTO_HASH
select NVMEM
help
USB4 and Thunderbolt driver. USB4 is the public specification
based on the Thunderbolt 3 protocol. This driver is required if
you want to hotplug Thunderbolt and USB4 compliant devices on
Apple hardware or on PCs with Intel Falcon Ridge or newer.
To compile this driver a module, choose M here. The module will be
called thunderbolt.
if USB4
config USB4_DEBUGFS_WRITE
bool "Enable write by debugfs to configuration spaces (DANGEROUS)"
help
Enables writing to device configuration registers through
debugfs interface. You can use tools such as Thunderbolt/USB4
debugging tools to access these registers. For more
information see:
https://github.com/intel/tbtools
Only enable this if you know what you are doing! Never enable
this for production systems or distro kernels.
config USB4_DEBUGFS_MARGINING
bool "Expose receiver lane margining operations under USB4 ports and retimers (DANGEROUS)"
depends on DEBUG_FS
depends on USB4_DEBUGFS_WRITE
help
Enables hardware and software based receiver lane margining
support under each USB4 port and retimer, including retimers
on the other side of the cable. Used for electrical quality
and robustness validation during manufacturing. Should not be
enabled by distro kernels.
config USB4_KUNIT_TEST
bool "KUnit tests" if !KUNIT_ALL_TESTS
depends on USB4 && KUNIT=y
default KUNIT_ALL_TESTS
config USB4_DMA_TEST
tristate "DMA traffic test driver"
depends on DEBUG_FS
help
This allows sending and receiving DMA traffic through loopback
connection. Loopback connection can be done by either special
dongle that has TX/RX lines crossed, or by simply connecting a
cable back to the host. Only enable this if you know what you
are doing. Normal users and distro kernels should say N here.
To compile this driver a module, choose M here. The module will be
called thunderbolt_dma_test.
endif # USB4