The primary aim of this patchset is to remove the pgprot_default and
prot_sect_default global variables and rely strictly on predefined
values. The original goal was to be able to run SMP kernels on UP
hardware by not setting the Shareability bit. However, it is unlikely to
see UP ARMv8 hardware and even if we do, the Shareability bit is no
longer assumed to disable cacheable accesses.
A side effect is that the device mappings now have the Shareability
attribute set. The hardware, however, should ignore it since Device
accesses are always Outer Shareable.
Following the removal of the two global variables, there is some PROT_*
macro reshuffling and cleanup, including the __PAGE_* macros (replaced
by PAGE_*).
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
Acked-by: Will Deacon <will.deacon@arm.com>
Fix for the arm64 kern_addr_valid() function to recognize
virtual addresses in the kernel logical memory map. The
function fails as written because it does not check whether
the addresses in that region are mapped at the pmd level to
2MB or 512MB pages, continues the page table walk to the
pte level, and issues a garbage value to pfn_valid().
Tested on 4K-page and 64K-page kernels.
Signed-off-by: Dave Anderson <anderson@redhat.com>
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
Add support for early IO or memory mappings which are needed before the
normal ioremap() is usable. This also adds fixmap support for permanent
fixed mappings such as that used by the earlyprintk device register
region.
Signed-off-by: Mark Salter <msalter@redhat.com>
Acked-by: Catalin Marinas <catalin.marinas@arm.com>
Cc: Borislav Petkov <borislav.petkov@amd.com>
Cc: Dave Young <dyoung@redhat.com>
Cc: H. Peter Anvin <hpa@zytor.com>
Cc: Will Deacon <will.deacon@arm.com>
Cc: Ingo Molnar <mingo@elte.hu>
Cc: Thomas Gleixner <tglx@linutronix.de>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Presently, paging_init() calls init_mem_pgprot() to initialize pgprot
values used by macros such as PAGE_KERNEL, PAGE_KERNEL_EXEC, etc.
The new fixmap and early_ioremap support also needs to use these macros
before paging_init() is called. This patch moves the init_mem_pgprot()
call out of paging_init() and into setup_arch() so that pgprot_default
gets initialized in time for fixmap and early_ioremap.
Signed-off-by: Mark Salter <msalter@redhat.com>
Acked-by: Catalin Marinas <catalin.marinas@arm.com>
Cc: Will Deacon <will.deacon@arm.com>
Cc: Borislav Petkov <borislav.petkov@amd.com>
Cc: Dave Young <dyoung@redhat.com>
Cc: H. Peter Anvin <hpa@zytor.com>
Cc: Ingo Molnar <mingo@elte.hu>
Cc: Thomas Gleixner <tglx@linutronix.de>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
With the 64K page size configuration, __create_page_tables in head.S
maps enough memory to get started but using 64K pages rather than 512M
sections with a single pgd/pud/pmd entry pointing to a pte table.
create_mapping() may override the pgd/pud/pmd table entry with a block
(section) one if the RAM size is more than 512MB and aligned correctly.
For the end of this block to be accessible, the old TLB entry must be
invalidated.
Cc: <stable@vger.kernel.org>
Reported-by: Mark Salter <msalter@redhat.com>
Tested-by: Mark Salter <msalter@redhat.com>
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
The map_mem() function limits the current memblock limit to PGDIR_SIZE
(the initial swapper_pg_dir mapping) to avoid create_mapping()
allocating memory from unmapped areas. However, if the first block is
within PGDIR_SIZE and not ending on a PMD_SIZE boundary, when 4K page
configuration is enabled, create_mapping() will try to allocate a pte
page. Such page may be returned by memblock_alloc() from the end of such
bank (or any subsequent bank within PGDIR_SIZE) which is not mapped yet.
The patch limits the current memblock limit to the aligned end of the
first bank and gradually increases it as more memory is mapped. It also
ensures that the start of the first bank is aligned to PMD_SIZE to avoid
pte page allocation for this mapping.
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
Reported-by: "Leizhen (ThunderTown, Euler)" <thunder.leizhen@huawei.com>
Tested-by: "Leizhen (ThunderTown, Euler)" <thunder.leizhen@huawei.com>
* 'for-next/hugepages' of git://git.linaro.org/people/stevecapper/linux:
ARM64: mm: THP support.
ARM64: mm: Raise MAX_ORDER for 64KB pages and THP.
ARM64: mm: HugeTLB support.
ARM64: mm: Move PTE_PROT_NONE bit.
ARM64: mm: Make PAGE_NONE pages read only and no-execute.
ARM64: mm: Restore memblock limit when map_mem finished.
mm: thp: Correct the HPAGE_PMD_ORDER check.
x86: mm: Remove general hugetlb code from x86.
mm: hugetlb: Copy general hugetlb code from x86 to mm.
x86: mm: Remove x86 version of huge_pmd_share.
mm: hugetlb: Copy huge_pmd_share from x86 to mm.
Conflicts:
arch/arm64/Kconfig
arch/arm64/include/asm/pgtable-hwdef.h
arch/arm64/include/asm/pgtable.h
In paging_init the memblock limit is set to restrict any addresses
returned by early_alloc to fit within the initial direct kernel
mapping in swapper_pg_dir. This allows map_mem to allocate puds,
pmds and ptes from the initial direct kernel mapping.
The limit stays low after paging_init() though, meaning any
bootmem allocations will be from a restricted subset of memory.
Gigabyte huge pages, for instance, are normally allocated from
bootmem as their order (18) is too large for the default buddy
allocator (MAX_ORDER = 11).
This patch restores the memblock limit when map_mem has finished,
allowing gigabyte huge pages (and other objects) to be allocated
from all of bootmem.
Signed-off-by: Steve Capper <steve.capper@linaro.org>
Acked-by: Catalin Marinas <catalin.marinas@arm.com>
The D-cache on AArch64 is VIPT non-aliasing, so there is no need to
flush it for anonymous pages.
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
Reported-by: Will Deacon <will.deacon@arm.com>
Acked-by: Will Deacon <will.deacon@arm.com>
The sparse code, when asking the architecture to populate the vmemmap,
specifies the section range as a starting page and a number of pages.
This is an awkward interface, because none of the arch-specific code
actually thinks of the range in terms of 'struct page' units and always
translates it to bytes first.
In addition, later patches mix huge page and regular page backing for
the vmemmap. For this, they need to call vmemmap_populate_basepages()
on sub-section ranges with PAGE_SIZE and PMD_SIZE in mind. But these
are not necessarily multiples of the 'struct page' size and so this unit
is too coarse.
Just translate the section range into bytes once in the generic sparse
code, then pass byte ranges down the stack.
Signed-off-by: Johannes Weiner <hannes@cmpxchg.org>
Cc: Ben Hutchings <ben@decadent.org.uk>
Cc: Bernhard Schmidt <Bernhard.Schmidt@lrz.de>
Cc: Johannes Weiner <hannes@cmpxchg.org>
Cc: Russell King <rmk@arm.linux.org.uk>
Cc: Ingo Molnar <mingo@elte.hu>
Cc: Thomas Gleixner <tglx@linutronix.de>
Cc: "H. Peter Anvin" <hpa@zytor.com>
Cc: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Cc: "Luck, Tony" <tony.luck@intel.com>
Cc: Heiko Carstens <heiko.carstens@de.ibm.com>
Acked-by: David S. Miller <davem@davemloft.net>
Tested-by: David S. Miller <davem@davemloft.net>
Cc: Wu Fengguang <fengguang.wu@intel.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
The 'CONFIG_' prefix is not implicit in IS_ENABLED().
Signed-off-by: Ben Hutchings <ben@decadent.org.uk>
Cc: Arnd Bergmann <arnd@arndb.de>
Cc: Paul Bolle <pebolle@tiscali.nl>
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
Introduce a new API vmemmap_free() to free and remove vmemmap
pagetables. Since pagetable implements are different, each architecture
has to provide its own version of vmemmap_free(), just like
vmemmap_populate().
Note: vmemmap_free() is not implemented for ia64, ppc, s390, and sparc.
[mhocko@suse.cz: fix implicit declaration of remove_pagetable]
Signed-off-by: Yasuaki Ishimatsu <isimatu.yasuaki@jp.fujitsu.com>
Signed-off-by: Jianguo Wu <wujianguo@huawei.com>
Signed-off-by: Wen Congyang <wency@cn.fujitsu.com>
Signed-off-by: Tang Chen <tangchen@cn.fujitsu.com>
Cc: KOSAKI Motohiro <kosaki.motohiro@jp.fujitsu.com>
Cc: Jiang Liu <jiang.liu@huawei.com>
Cc: Kamezawa Hiroyuki <kamezawa.hiroyu@jp.fujitsu.com>
Cc: Lai Jiangshan <laijs@cn.fujitsu.com>
Cc: Wu Jianguo <wujianguo@huawei.com>
Cc: Ingo Molnar <mingo@elte.hu>
Cc: Thomas Gleixner <tglx@linutronix.de>
Cc: "H. Peter Anvin" <hpa@zytor.com>
Signed-off-by: Michal Hocko <mhocko@suse.cz>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
This patch adds support for "earlyprintk=" parameter on the kernel
command line. The format is:
earlyprintk=<name>[,<addr>][,<options>]
where <name> is the name of the (UART) device, e.g. "pl011", <addr> is
the I/O address. The <options> aren't currently used.
The mapping of the earlyprintk device is done very early during kernel
boot and there are restrictions on which functions it can call. A
special early_io_map() function is added which creates the mapping from
the pre-defined EARLY_IOBASE to the device I/O address passed via the
kernel parameter. The pgd entry corresponding to EARLY_IOBASE is
pre-populated in head.S during kernel boot.
Only PL011 is currently supported and it is assumed that the interface
is already initialised by the boot loader before the kernel is started.
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
Acked-by: Arnd Bergmann <arnd@arndb.de>
This patch contains the initialisation of the memory blocks, MMU
attributes and the memory map. Only five memory types are defined:
Device nGnRnE (equivalent to Strongly Ordered), Device nGnRE (classic
Device memory), Device GRE, Normal Non-cacheable and Normal Cacheable.
Cache policies are supported via the memory attributes register
(MAIR_EL1) and only affect the Normal Cacheable mappings.
This patch also adds the SPARSEMEM_VMEMMAP initialisation.
Signed-off-by: Will Deacon <will.deacon@arm.com>
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
Acked-by: Tony Lindgren <tony@atomide.com>
Acked-by: Nicolas Pitre <nico@linaro.org>
Acked-by: Olof Johansson <olof@lixom.net>
Acked-by: Santosh Shilimkar <santosh.shilimkar@ti.com>
Acked-by: Arnd Bergmann <arnd@arndb.de>
