From: Alexey Kuznetsov <kuznet@ms2.inr.ac.ru>
Handle better the case where the sender sends full sized
frames initially, then moves to a mode where it trickles
out small amounts of data at a time.
This known problem is even mentioned in the comments
above tcp_grow_window() in tcp_input.c, specifically:
...
* The scheme does not work when sender sends good segments opening
* window and then starts to feed us spagetti. But it should work
* in common situations. Otherwise, we have to rely on queue collapsing.
...
When the sender gives full sized frames, the "struct sk_buff" overhead
from each packet is small. So we'll advertize a larger window.
If the sender moves to a mode where small segments are sent, this
ratio becomes tilted to the other extreme and we start overrunning
the socket buffer space.
tcp_clamp_window() tries to address this, but it's clamping of
tp->window_clamp is a wee bit too aggressive for this particular case.
Fix confirmed by Ion Badulescu.
Signed-off-by: David S. Miller <davem@davemloft.net>
But retain the comment fix.
Alexey Kuznetsov has explained the situation as follows:
--------------------
I think the fix is incorrect. Look, the RFC function init_cwnd(mss) is
not continuous: f.e. for mss=1095 it needs initial window 1095*4, but
for mss=1096 it is 1096*3. We do not know exactly what mss sender used
for calculations. If we advertised 1096 (and calculate initial window
3*1096), the sender could limit it to some value < 1096 and then it
will need window his_mss*4 > 3*1096 to send initial burst.
See?
So, the honest function for inital rcv_wnd derived from
tcp_init_cwnd() is:
init_rcv_wnd(mss)=
min { init_cwnd(mss1)*mss1 for mss1 <= mss }
It is something sort of:
if (mss < 1096)
return mss*4;
if (mss < 1096*2)
return 1096*4;
return mss*2;
(I just scrablled a graph of piece of paper, it is difficult to see or
to explain without this)
I selected it differently giving more window than it is strictly
required. Initial receive window must be large enough to allow sender
following to the rfc (or just setting initial cwnd to 2) to send
initial burst. But besides that it is arbitrary, so I decided to give
slack space of one segment.
Actually, the logic was:
If mss is low/normal (<=ethernet), set window to receive more than
initial burst allowed by rfc under the worst conditions
i.e. mss*4. This gives slack space of 1 segment for ethernet frames.
For msses slighlty more than ethernet frame, take 3. Try to give slack
space of 1 frame again.
If mss is huge, force 2*mss. No slack space.
Value 1460*3 is really confusing. Minimal one is 1096*2, but besides
that it is an arbitrary value. It was meant to be ~4096. 1460*3 is
just the magic number from RFC, 1460*3 = 1095*4 is the magic :-), so
that I guess hands typed this themselves.
--------------------
Signed-off-by: David S. Miller <davem@davemloft.net>
A bunch of create_proc_dir_entry() calls creating directories had crept
in since the last sweep; converted to proc_mkdir().
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
From: Oliver Dawid <oliver@helios.de>
we found a bug in net/appletalk/ddp.c concerning broadcast packets. In
kernel 2.4 it was working fine. The bug first occured 4 years ago when
switching to new SNAP layer handling. This bug can be splitted up into a
sending(1) and reception(2) problem:
Sending(1)
In kernel 2.4 broadcast packets were sent to a matching ethernet device
and atalk_rcv() was called to receive it as "loopback" (so loopback
packets were shortcutted and handled in DDP layer).
When switching to the new SNAP structure, this shortcut was removed and
the loopback packet was send to SNAP layer. The author forgot to replace
the remote device pointer by the loopback device pointer before sending
the packet to SNAP layer (by calling ddp_dl->request() ) therfor the
packet was not sent back by underlying layers to ddp's atalk_rcv().
Reception(2)
In atalk_rcv() a packet received by this loopback mechanism contains now
the (rigth) loopback device pointer (in Kernel 2.4 it was the (wrong)
remote ethernet device pointer) and therefor no matching socket will be
found to deliver this packet to. Because a broadcast packet should be
send to the first matching socket (as it is done in many other protocols
(?)), we removed the network comparison in broadcast case.
Below you will find a patch to correct this bug. Its diffed to kernel
2.6.14-rc1
Signed-off-by: Arnaldo Carvalho de Melo <acme@ghostprotocols.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
We know the thing is at least 2-byte aligned, so take
advantage of that instead of invoking memcmp() which
results in truly horrifically inefficient code because
it can't assume anything about alignment.
Signed-off-by: David S. Miller <davem@davemloft.net>
* Don't bother with proto registering if rose_ndevs is bad.
* Make escape structure more coherent.
Signed-off-by: Alexey Dobriyan <adobriyan@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
I have been experimenting with loadable protocol modules, and ran into
several issues with module reference counting.
The first issue was that __module_get failed at the BUG_ON check at
the top of the routine (checking that my module reference count was
not zero) when I created the first socket. When sk_alloc() is called,
my module reference count was still 0. When I looked at why sctp
didn't have this problem, I discovered that sctp creates a control
socket during module init (when the module ref count is not 0), which
keeps the reference count non-zero. This section has been updated to
address the point Stephen raised about checking the return value of
try_module_get().
The next problem arose when my socket init routine returned an error.
This resulted in my module reference count being decremented below 0.
My socket ops->release routine was also being called. The issue here
is that sock_release() calls the ops->release routine and decrements
the ref count if sock->ops is not NULL. Since the socket probably
didn't get correctly initialized, this should not be done, so we will
set sock->ops to NULL because we will not call try_module_get().
While searching for another bug, I also noticed that sys_accept() has
a possibility of doing a module_put() when it did not do an
__module_get so I re-ordered the call to security_socket_accept().
Signed-off-by: Frank Filz <ffilzlnx@us.ibm.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Use iteration instead of recursion. Fraglists within fraglists
should never occur, so we BUG check this.
Signed-off-by: Daniel Phillips <phillips@istop.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
If we double-add a neighbour entry timer, which should be
impossible but has been reported, dump the current state of
the entry so that we can debug this.
Signed-off-by: David S. Miller <davem@davemloft.net>
When you've enabled conntrack and NAT as a module (standard case in all
distributions), and you've also enabled the new conntrack netlink
interface, loading ip_conntrack_netlink.ko will auto-load iptable_nat.ko.
This causes a huge performance penalty, since for every packet you iterate
the nat code, even if you don't want it.
This patch splits iptable_nat.ko into the NAT core (ip_nat.ko) and the
iptables frontend (iptable_nat.ko). Threfore, ip_conntrack_netlink.ko will
only pull ip_nat.ko, but not the frontend. ip_nat.ko will "only" allocate
some resources, but not affect runtime performance.
This separation is also a nice step in anticipation of new packet filters
(nf-hipac, ipset, pkttables) being able to use the NAT core.
Signed-off-by: Harald Welte <laforge@netfilter.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
These broke existing apps, and the checks are superfluous
as the values being verified aren't even used.
Signed-off-by: David S. Miller <davem@davemloft.net>
> Steps to reproduce:
> 1. Boot Linux, do NOT setup any IPv6 routes
> 2. ip route get 2001::1 (or any unroutable address)
Well caught. We never set rt6i_idev on ip6_null_entry.
This patch should make the problem go away.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Acked-by: YOSHIFUJI Hideaki <yoshfuji@linux-ipv6.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
It's on the stack and declared as "unsigned char[]", but pointers
and similar can be in here thus we need to give it an explicit
alignment attribute.
Signed-off-by: Alex Williamson <alex.williamson@hp.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
The GRE, SCTP and TCP protocol helpers did not call
ip_conntrack_event_cache() when updating ct->status. This patch adds
the respective calls.
Signed-off-by: Harald Welte <laforge@netfilter.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
From: Amos Waterland <apw@us.ibm.com>
If CONFIG_PROC_FS is not selected, the compiler emits this warning:
net/core/neighbour.c:64: warning: `neigh_stat_seq_fops' defined but not used
Which is correct, because neigh_stat_seq_fops is in fact only
initialized and used by code that is protected by CONFIG_PROC_FS. So
this patch fixes that up.
Signed-off-by: Amos Waterland <apw@us.ibm.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
We have to introduce a separate Kconfig menu entry for the NFQUEUE targets.
They cannot "just" depend on nfnetlink_queue, since nfnetlink_queue could
be linked into the kernel, whereas iptables can be a module.
Signed-off-by: Harald Welte <laforge@netfilter.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Fix to allow SCTP_SHUTDOWN notifications to be received on 1-1 style
SCTP SOCK_STREAM sockets.
Add SCTP_SHUTDOWN notification to the receive queue before updating
the state of the association.
Signed-off-by: Sridhar Samudrala <sri@us.ibm.com>
Signed-off-by: Neil Horman <nhorman@tuxdriver.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
This patch fixes a number of bugs. It cannot be reasonably split up in
multiple fixes, since all bugs interact with each other and affect the same
function:
Bug #1:
The event cache code cannot be called while a lock is held. Therefore, the
call to ip_conntrack_event_cache() within ip_ct_refresh_acct() needs to be
moved outside of the locked section. This fixes a number of 2.6.14-rcX
oops and deadlock reports.
Bug #2:
We used to call ct_add_counters() for unconfirmed connections without
holding a lock. Since the add operations are not atomic, we could race
with another CPU.
Bug #3:
ip_ct_refresh_acct() lost REFRESH events in some cases where refresh
(and the corresponding event) are desired, but no accounting shall be
performed. Both, evenst and accounting implicitly depended on the skb
parameter bein non-null. We now re-introduce a non-accounting
"ip_ct_refresh()" variant to explicitly state the desired behaviour.
Signed-off-by: Harald Welte <laforge@netfilter.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Signed-off-by: Alexey Dobriyan <adobriyan@gmail.com>
Signed-off-by: Harald Welte <laforge@netfilter.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
As noted by Alexey Dobriyan, the DEBUGP statement prints the wrong
callID.
Signed-off-by: Harald Welte <laforge@netfilter.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Since the introduction of TSO pcount a year ago, it has been possible
for tcp_fragment() to cause packets_out to decrease. Prior to that,
tcp_retrans_try_collapse() was the only way for that to happen on the
retransmission path.
When this happens with Reno, it is possible for sasked_out to become
invalid because it is only an estimate and not tied to any particular
packet on the retransmission queue.
Therefore we need to adjust sacked_out as well as left_out in the Reno
case. The following patch does exactly that.
This bug is pretty difficult to trigger in practice though since you
need a SACKless peer with a retransmission that occurs just as the
cached MTU value expires.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Signed-off-by: David S. Miller <davem@davemloft.net>
Borrowing the structure of TCP/IP for this. On the receive of new connections I
was bh_lock_socking the _new_ sock, not the listening one, duh, now it survives
the ssh connections storm I've been using to test this specific bug.
Also fixes send side skb sock accounting.
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
llc_fixup_skb() had a bug dropping 3 bytes packets (like UA frames). Token ring
doesn't pad these frames.
Signed-off-by: Jochen Friedrich <jochen@scram.de>
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
