Adds the sun6i_hwspinlock driver for the hardware spinlock unit found in
most of the sun6i compatible SoCs.
This unit provides at least 32 spinlocks in hardware. The implementation
supports 32, 64, 128 or 256 32bit registers. A lock can be taken by
reading a register and released by writing a 0 to it. This driver
supports all 4 spinlock setups, but for now only the first setup (32
locks) seem to exist in available devices. This spinlock unit is shared
between all ARM cores and the embedded companion core. All of them can
take/release a lock with a single cycle operation. It can be used to
sync access to devices shared by the ARM cores and the companion core.
There are two ways to check if a lock is taken. The first way is to read
a lock. If a 0 is returned, the lock was free and is taken now. If an 1
is returned, the caller has to try again. Which means the lock is taken.
The second way is to read a 32bit wide status register where every bit
represents one of the 32 first locks. According to the datasheets this
status register supports only the 32 first locks. This is the reason the
first way (lock read/write) approach is used to be able to cover all 256
locks in future devices. The driver also reports the amount of supported
locks via debugfs.
Reviewed-by: Samuel Holland <samuel@sholland.org>
Acked-by: Maxime Ripard <maxime@cerno.tech>
Signed-off-by: Wilken Gottwalt <wilken.gottwalt@posteo.net>
Link: https://lore.kernel.org/r/bfd2b97307c2321b15c09683f4bd5e1fcc792f13.1615713499.git.wilken.gottwalt@posteo.net
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Every hwspinlock driver is expected to depend on the
hwspinlock core, so it's possible to simplify the
Kconfig, factoring out the HWSPINLOCK dependency.
Reviewed-by: Baolin Wang <baolin.wang7@gmail.com>
Signed-off-by: Ezequiel Garcia <ezequiel@collabora.com>
Link: https://lore.kernel.org/r/20200414220943.6203-1-ezequiel@collabora.com
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
A HwSpinlock IP is also present on the newer TI K3 AM65x and J721E
family of SoCs within the Main NavSS sub-module. Reuse the existing
OMAP Hwspinlock driver to extend the support for this IP on K3 AM65x
SoCs as well. The IP has slightly different bit-fields in the
SYSCONFIG and SYSSTATUS registers.
Signed-off-by: Suman Anna <s-anna@ti.com>
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
This patch adds support of hardware semaphores for stm32mp1 SoC.
The hardware block provides 32 semaphores.
Signed-off-by: Benjamin Gaignard <benjamin.gaignard@st.com>
Signed-off-by: Benjamin Gaignard <benjamin.gaignard@linaro.org>
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Use the appropriate SPDX license identifier in the Hwspinlock core
driver source files and drop the previous boilerplate license text.
Signed-off-by: Suman Anna <s-anna@ti.com>
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Change hwspinlock to a bool in case some drivers will meet dependency
issue when hwspinlock is built as a module.
Signed-off-by: Baolin Wang <baolin.wang@linaro.org>
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
The Spreadtrum hardware spinlock device can provide hardware assistance
for synchronization between the multiple subsystems.
Signed-off-by: Baolin Wang <baolin.wang@spreadtrum.com>
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
So that there's no need to get into the submenu to disable all related config
entries.
Signed-off-by: Vincent Legoll <vincent.legoll@gmail.com>
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Add hwspinlock support for the CSR atlas7 SoC.
The Hardware Spinlock device on atlas7 provides hardware assistance
for synchronization between the multiple processors in the system
(dual Cortex-A7, CAN bus Cortex-M3 and audio DSP).
Reviewed-by: Suman Anna <s-anna@ti.com>
Reviewed-by: Bjorn Andersson <bjorn.andersson@sonymobile.com>
Signed-off-by: Wei Chen <wei.chen@csr.com>
Signed-off-by: Barry Song <Baohua.Song@csr.com>
Signed-off-by: Ohad Ben-Cohen <ohad@wizery.com>
Add driver for Qualcomm Hardware Mutex block found in many Qualcomm
SoCs.
Based on initial effort by Kumar Gala <galak@codeaurora.org>
Signed-off-by: Bjorn Andersson <bjorn.andersson@sonymobile.com>
Reviewed-by: Andy Gross <agross@codeaurora.org>
Reviewed-by: Jeffrey Hugo <jhugo@codeaurora.org>
Signed-off-by: Ohad Ben-Cohen <ohad@wizery.com>
HwSpinlocks are supported on TI's AM33xx, AM43xx and DRA7xx SoC
device families as well. The IPs are identical to that of
OMAP4/OMAP5, except for the number of locks.
Add a depends on to the above family of SoCs to enable the
build support for OMAP hwspinlock driver for any of the above
SoC configs.
Signed-off-by: Suman Anna <s-anna@ti.com>
[small commit log changes]
Signed-off-by: Ohad Ben-Cohen <ohad@wizery.com>
Add hwspinlock driver for U8500's Hsem hardware.
At this point only HSem's protocol 1 is used (i.e. no interrupts).
Signed-off-by: Mathieu Poirier <mathieu.poirier@linaro.org>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
[ohad@wizery.com: adopt recent hwspin_lock_{un}register API changes]
[ohad@wizery.com: set the owner member of the driver]
[ohad@wizery.com: mark ->remove() function as __devexit]
[ohad@wizery.com: write commit log]
[ohad@wizery.com: small cleanups]
Signed-off-by: Ohad Ben-Cohen <ohad@wizery.com>
Simplify hwspinlock's Kconfig by making the global CONFIG_HWSPINLOCK
entry invisible; users will just select it when needed.
This also prepares the ground for adding hwspinlock support for other
platforms (the 'depends on ARCH_OMAP4' was rather hideous, and while
we're at it, a dedicated menu is added).
Signed-off-by: Ohad Ben-Cohen <ohad@wizery.com>
Currently only OMAP4 supports hwspinlocks, so don't bother asking
anyone else.
Signed-off-by: Ohad Ben-Cohen <ohad@wizery.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
Add hwspinlock support for the OMAP4 Hardware Spinlock device.
The Hardware Spinlock device on OMAP4 provides hardware assistance
for synchronization between the multiple processors in the system
(dual Cortex-A9, dual Cortex-M3 and a C64x+ DSP).
[ohad@wizery.com: adapt to hwspinlock framework, tidy up]
Signed-off-by: Simon Que <sque@ti.com>
Signed-off-by: Hari Kanigeri <h-kanigeri2@ti.com>
Signed-off-by: Krishnamoorthy, Balaji T <balajitk@ti.com>
Signed-off-by: Ohad Ben-Cohen <ohad@wizery.com>
Cc: Benoit Cousson <b-cousson@ti.com>
Cc: Kevin Hilman <khilman@ti.com>
Cc: Grant Likely <grant.likely@secretlab.ca>
Cc: Arnd Bergmann <arnd@arndb.de>
Cc: Paul Walmsley <paul@pwsan.com>
Cc: Russell King <linux@arm.linux.org.uk>
Signed-off-by: Tony Lindgren <tony@atomide.com>
Add a platform-independent hwspinlock framework.
Hardware spinlock devices are needed, e.g., in order to access data
that is shared between remote processors, that otherwise have no
alternative mechanism to accomplish synchronization and mutual exclusion
operations.
Signed-off-by: Ohad Ben-Cohen <ohad@wizery.com>
Cc: Hari Kanigeri <h-kanigeri2@ti.com>
Cc: Benoit Cousson <b-cousson@ti.com>
Cc: Kevin Hilman <khilman@ti.com>
Cc: Grant Likely <grant.likely@secretlab.ca>
Cc: Paul Walmsley <paul@pwsan.com>
Cc: Russell King <linux@arm.linux.org.uk>
Acked-by: Arnd Bergmann <arnd@arndb.de>
Signed-off-by: Tony Lindgren <tony@atomide.com>
