Minki/linux
1
0
Fork 1
mirror of https://github.com/torvalds/linux.git synced 2024-11-15 08:31:55 +00:00
Code Issues Packages Projects Releases Wiki Activity

pinctrl: amd: disable spurious-firing GPIO IRQs

Browse Source 
When cold-booting Asus X434DA, GPIO 7 is found to be already configured
as an interrupt, and the GPIO level is found to be in a state that
causes the interrupt to fire.

As soon as pinctrl-amd probes, this interrupt fires and invokes
amd_gpio_irq_handler(). The IRQ is acked, but no GPIO-IRQ handler was
invoked, so the GPIO level being unchanged just causes another interrupt
to fire again immediately after.

This results in an interrupt storm causing this platform to hang
during boot, right after pinctrl-amd is probed.

Detect this situation and disable the GPIO interrupt when this happens.
This enables the affected platform to boot as normal. GPIO 7 actually is
the I2C touchpad interrupt line, and later on, i2c-multitouch loads and
re-enables this interrupt when it is ready to handle it.

Instead of this approach, I considered disabling all GPIO interrupts at
probe time, however that seems a little risky, and I also confirmed that
Windows does not seem to have this behaviour: the same 41 GPIO IRQs are
enabled under both Linux and Windows, which is a far larger collection
than the GPIOs referenced by the DSDT on this platform.

Signed-off-by: Daniel Drake <drake@endlessm.com>
Link: https://lore.kernel.org/r/20190814090540.7152-1-drake@endlessm.com
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
This commit is contained in:
Daniel Drake 2019-08-14 17:05:40 +08:00 committed by Linus Walleij
parent 880e4f93f9
commit d21b8adbd4
1 changed files with 11 additions and 1 deletions
Show Stats Download Patch File Download Diff File Expand all files Collapse all files

12
drivers/pinctrl/pinctrl-amd.c
View File

@ -565,15 +565,25 @@ static irqreturn_t amd_gpio_irq_handler(int irq, void *dev_id)
!(regval & BIT(INTERRUPT_MASK_OFF)))
continue;
irq = irq_find_mapping(gc->irq.domain, irqnr + i);
generic_handle_irq(irq);
if (irq != 0)
generic_handle_irq(irq);
/* Clear interrupt.
* We must read the pin register again, in case the
* value was changed while executing
* generic_handle_irq() above.
* If we didn't find a mapping for the interrupt,
* disable it in order to avoid a system hang caused
* by an interrupt storm.
*/
raw_spin_lock_irqsave(&gpio_dev->lock, flags);
regval = readl(regs + i);
if (irq == 0) {
regval &= ~BIT(INTERRUPT_ENABLE_OFF);
dev_dbg(&gpio_dev->pdev->dev,
"Disabling spurious GPIO IRQ %d\n",
irqnr + i);
}
writel(regval, regs + i);
raw_spin_unlock_irqrestore(&gpio_dev->lock, flags);
ret = IRQ_HANDLED;