remoteproc: stm32: clear MCU PDDS at firmware start

When remoteproc stops a firmware, it sets the MCU PDDS flag, allowing
the platform to reach the Standby power mode if needed.
Symmetrically, clear this flag before running a firmware.
This fixes the issue where the system goes to Standby mode when the
MCU crashes while MPU is in CSTOP mode.

Signed-off-by: Fabien Dessenne <fabien.dessenne@st.com>
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
This commit is contained in:
Fabien Dessenne 2019-08-26 17:38:06 +02:00 committed by Bjorn Andersson
parent f2583fde27
commit abbe429d56

View File

@ -383,10 +383,21 @@ static void stm32_rproc_add_coredump_trace(struct rproc *rproc)
static int stm32_rproc_start(struct rproc *rproc)
{
struct stm32_rproc *ddata = rproc->priv;
int err;
stm32_rproc_add_coredump_trace(rproc);
/* clear remote proc Deep Sleep */
if (ddata->pdds.map) {
err = regmap_update_bits(ddata->pdds.map, ddata->pdds.reg,
ddata->pdds.mask, 0);
if (err) {
dev_err(&rproc->dev, "failed to clear pdds\n");
return err;
}
}
err = stm32_rproc_set_hold_boot(rproc, false);
if (err)
return err;