cxlflash: Remove unused variable from queuecommand

The queuecommand routine has a local dev pointer used for the
dev_* prints. The two prints that currently exist are tucked
under a debug define and thus can be left out. Use the actual
location instead of a local to avoid this warning.

This patch is intended to be applied after the "CXL Flash Error
Recovery and Superpipe" series.

Signed-off-by: Matthew R. Ochs <mrochs@linux.vnet.ibm.com>
Signed-off-by: Manoj N. Kumar <manoj@linux.vnet.ibm.com>
Reported-by: kbuild test robot <fengguang.wu@intel.com>
Signed-off-by: James Bottomley <JBottomley@Odin.com>
This commit is contained in:
Matthew R. Ochs 2015-08-26 18:36:12 -05:00 committed by James Bottomley
parent 4da74db0d9
commit 89576205de

View File

@ -354,7 +354,6 @@ static int cxlflash_queuecommand(struct Scsi_Host *host, struct scsi_cmnd *scp)
struct cxlflash_cfg *cfg = (struct cxlflash_cfg *)host->hostdata;
struct afu *afu = cfg->afu;
struct pci_dev *pdev = cfg->dev;
struct device *dev = &cfg->dev->dev;
struct afu_cmd *cmd;
u32 port_sel = scp->device->channel + 1;
int nseg, i, ncount;
@ -384,11 +383,13 @@ static int cxlflash_queuecommand(struct Scsi_Host *host, struct scsi_cmnd *scp)
switch (cfg->state) {
case STATE_LIMBO:
dev_dbg_ratelimited(dev, "%s: device in limbo!\n", __func__);
dev_dbg_ratelimited(&cfg->dev->dev, "%s: device in limbo!\n",
__func__);
rc = SCSI_MLQUEUE_HOST_BUSY;
goto out;
case STATE_FAILTERM:
dev_dbg_ratelimited(dev, "%s: device has failed!\n", __func__);
dev_dbg_ratelimited(&cfg->dev->dev, "%s: device has failed!\n",
__func__);
scp->result = (DID_NO_CONNECT << 16);
scp->scsi_done(scp);
rc = 0;