mm, hotplug: probe interface is available on several platforms

Documentation/memory-hotplug.txt incorrectly states that the memory
driver "probe" interface is only supported on powerpc and is vague about
its application on x86.  Clarify the platforms that make this interface
available if memory hotplug is enabled.

Signed-off-by: David Rientjes <rientjes@google.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
This commit is contained in:
David Rientjes 2014-06-23 13:22:03 -07:00 committed by Linus Torvalds
parent b3acc56bfe
commit 7cdb0d25bc

View File

@ -209,15 +209,12 @@ If memory device is found, memory hotplug code will be called.
4.2 Notify memory hot-add event by hand
------------
On powerpc, the firmware does not notify a memory hotplug event to the kernel.
Therefore, "probe" interface is supported to notify the event to the kernel.
This interface depends on CONFIG_ARCH_MEMORY_PROBE.
CONFIG_ARCH_MEMORY_PROBE is supported on powerpc only. On x86, this config
option is disabled by default since ACPI notifies a memory hotplug event to
the kernel, which performs its hotplug operation as the result. Please
enable this option if you need the "probe" interface for testing purposes
on x86.
On some architectures, the firmware may not notify the kernel of a memory
hotplug event. Therefore, the memory "probe" interface is supported to
explicitly notify the kernel. This interface depends on
CONFIG_ARCH_MEMORY_PROBE and can be configured on powerpc, sh, and x86
if hotplug is supported, although for x86 this should be handled by ACPI
notification.
Probe interface is located at
/sys/devices/system/memory/probe