w1: ds2413: when the slave is not responding during read, select it again

The protocol is not allowing to obtain a byte of 0xff for PIO_ACCESS_READ
call. It is very likely that the slave was not addressed properly and
it is just not respoding (leaving the bus in logic high state) during
the read of sampled PIO value.
We cannot just call w1_reset_resume_command() because the problem will
persist, instead try selecting (addressing) the slave again.

Signed-off-by: Mariusz Bialonczyk <manio@skyboo.net>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
This commit is contained in:
Mariusz Bialonczyk 2019-05-22 12:40:53 +02:00 committed by Greg Kroah-Hartman
parent c50d09a861
commit 3856032a06

View File

@ -24,6 +24,7 @@
#define W1_F3A_FUNC_PIO_ACCESS_READ 0xF5 #define W1_F3A_FUNC_PIO_ACCESS_READ 0xF5
#define W1_F3A_FUNC_PIO_ACCESS_WRITE 0x5A #define W1_F3A_FUNC_PIO_ACCESS_WRITE 0x5A
#define W1_F3A_SUCCESS_CONFIRM_BYTE 0xAA #define W1_F3A_SUCCESS_CONFIRM_BYTE 0xAA
#define W1_F3A_INVALID_PIO_STATE 0xFF
static ssize_t state_read(struct file *filp, struct kobject *kobj, static ssize_t state_read(struct file *filp, struct kobject *kobj,
struct bin_attribute *bin_attr, char *buf, loff_t off, struct bin_attribute *bin_attr, char *buf, loff_t off,
@ -45,6 +46,7 @@ static ssize_t state_read(struct file *filp, struct kobject *kobj,
mutex_lock(&sl->master->bus_mutex); mutex_lock(&sl->master->bus_mutex);
dev_dbg(&sl->dev, "mutex locked"); dev_dbg(&sl->dev, "mutex locked");
next:
if (w1_reset_select_slave(sl)) if (w1_reset_select_slave(sl))
goto out; goto out;
@ -52,10 +54,15 @@ static ssize_t state_read(struct file *filp, struct kobject *kobj,
w1_write_8(sl->master, W1_F3A_FUNC_PIO_ACCESS_READ); w1_write_8(sl->master, W1_F3A_FUNC_PIO_ACCESS_READ);
*buf = w1_read_8(sl->master); *buf = w1_read_8(sl->master);
/* check for correct complement */
if ((*buf & 0x0F) == ((~*buf >> 4) & 0x0F)) { if ((*buf & 0x0F) == ((~*buf >> 4) & 0x0F)) {
/* complement is correct */
bytes_read = 1; bytes_read = 1;
goto out; goto out;
} else if (*buf == W1_F3A_INVALID_PIO_STATE) {
/* slave didn't respond, try to select it again */
dev_warn(&sl->dev, "slave device did not respond to PIO_ACCESS_READ, " \
"reselecting, retries left: %d\n", retries);
goto next;
} }
if (w1_reset_resume_command(sl->master)) if (w1_reset_resume_command(sl->master))