diff --git a/drivers/tty/serial/Kconfig b/drivers/tty/serial/Kconfig index f5a88e75dda6..da45877e79fb 100644 --- a/drivers/tty/serial/Kconfig +++ b/drivers/tty/serial/Kconfig @@ -1179,15 +1179,42 @@ config SERIAL_SCCNXP_CONSOLE help Support for console on SCCNXP serial ports. +config SERIAL_SC16IS7XX_CORE + tristate + config SERIAL_SC16IS7XX - tristate "SC16IS7xx serial support" - depends on I2C - select SERIAL_CORE - select REGMAP_I2C if I2C - help - This selects support for SC16IS7xx serial ports. - Supported ICs are SC16IS740, SC16IS741, SC16IS750, SC16IS752, - SC16IS760 and SC16IS762. + tristate "SC16IS7xx serial support" + select SERIAL_CORE + depends on I2C || SPI_MASTER + help + This selects support for SC16IS7xx serial ports. + Supported ICs are SC16IS740, SC16IS741, SC16IS750, SC16IS752, + SC16IS760 and SC16IS762. Select supported buses using options below. + +config SERIAL_SC16IS7XX_I2C + bool "SC16IS7xx for I2C interface" + depends on SERIAL_SC16IS7XX + depends on I2C + select SERIAL_SC16IS7XX_CORE if SERIAL_SC16IS7XX + select REGMAP_I2C if I2C + default y + help + Enable SC16IS7xx driver on I2C bus, + If required say y, and say n to i2c if not required, + Enabled by default to support oldconfig. + You must select at least one bus for the driver to be built. + +config SERIAL_SC16IS7XX_SPI + bool "SC16IS7xx for spi interface" + depends on SERIAL_SC16IS7XX + depends on SPI_MASTER + select SERIAL_SC16IS7XX_CORE if SERIAL_SC16IS7XX + select REGMAP_SPI if SPI_MASTER + help + Enable SC16IS7xx driver on SPI bus, + If required say y, and say n to spi if not required, + This is additional support to exsisting driver. + You must select at least one bus for the driver to be built. config SERIAL_BFIN_SPORT tristate "Blackfin SPORT emulate UART" diff --git a/drivers/tty/serial/Makefile b/drivers/tty/serial/Makefile index 432cb6465227..d296cee2e132 100644 --- a/drivers/tty/serial/Makefile +++ b/drivers/tty/serial/Makefile @@ -53,7 +53,7 @@ obj-$(CONFIG_SERIAL_SB1250_DUART) += sb1250-duart.o obj-$(CONFIG_ETRAX_SERIAL) += crisv10.o obj-$(CONFIG_SERIAL_ETRAXFS) += etraxfs-uart.o obj-$(CONFIG_SERIAL_SCCNXP) += sccnxp.o -obj-$(CONFIG_SERIAL_SC16IS7XX) += sc16is7xx.o +obj-$(CONFIG_SERIAL_SC16IS7XX_CORE) += sc16is7xx.o obj-$(CONFIG_SERIAL_JSM) += jsm/ obj-$(CONFIG_SERIAL_TXX9) += serial_txx9.o obj-$(CONFIG_SERIAL_VR41XX) += vr41xx_siu.o diff --git a/drivers/tty/serial/sc16is7xx.c b/drivers/tty/serial/sc16is7xx.c index 468354ef7baa..d1c046da7853 100644 --- a/drivers/tty/serial/sc16is7xx.c +++ b/drivers/tty/serial/sc16is7xx.c @@ -25,6 +25,7 @@ #include #include #include +#include #include #define SC16IS7XX_NAME "sc16is7xx" @@ -1204,6 +1205,73 @@ static struct regmap_config regcfg = { .precious_reg = sc16is7xx_regmap_precious, }; +#ifdef CONFIG_SERIAL_SC16IS7XX_SPI +static int sc16is7xx_spi_probe(struct spi_device *spi) +{ + struct sc16is7xx_devtype *devtype; + unsigned long flags = 0; + struct regmap *regmap; + int ret; + + /* Setup SPI bus */ + spi->bits_per_word = 8; + /* only supports mode 0 on SC16IS762 */ + spi->mode = spi->mode ? : SPI_MODE_0; + spi->max_speed_hz = spi->max_speed_hz ? : 15000000; + ret = spi_setup(spi); + if (ret) + return ret; + + if (spi->dev.of_node) { + const struct of_device_id *of_id = + of_match_device(sc16is7xx_dt_ids, &spi->dev); + + devtype = (struct sc16is7xx_devtype *)of_id->data; + } else { + const struct spi_device_id *id_entry = spi_get_device_id(spi); + + devtype = (struct sc16is7xx_devtype *)id_entry->driver_data; + flags = IRQF_TRIGGER_FALLING; + } + + regcfg.max_register = (0xf << SC16IS7XX_REG_SHIFT) | + (devtype->nr_uart - 1); + regmap = devm_regmap_init_spi(spi, ®cfg); + + return sc16is7xx_probe(&spi->dev, devtype, regmap, spi->irq, flags); +} + +static int sc16is7xx_spi_remove(struct spi_device *spi) +{ + return sc16is7xx_remove(&spi->dev); +} + +static const struct spi_device_id sc16is7xx_spi_id_table[] = { + { "sc16is74x", (kernel_ulong_t)&sc16is74x_devtype, }, + { "sc16is750", (kernel_ulong_t)&sc16is750_devtype, }, + { "sc16is752", (kernel_ulong_t)&sc16is752_devtype, }, + { "sc16is760", (kernel_ulong_t)&sc16is760_devtype, }, + { "sc16is762", (kernel_ulong_t)&sc16is762_devtype, }, + { } +}; + +MODULE_DEVICE_TABLE(spi, sc16is7xx_spi_id_table); + +static struct spi_driver sc16is7xx_spi_uart_driver = { + .driver = { + .name = SC16IS7XX_NAME, + .owner = THIS_MODULE, + .of_match_table = of_match_ptr(sc16is7xx_dt_ids), + }, + .probe = sc16is7xx_spi_probe, + .remove = sc16is7xx_spi_remove, + .id_table = sc16is7xx_spi_id_table, +}; + +MODULE_ALIAS("spi:sc16is7xx"); +#endif + +#ifdef CONFIG_SERIAL_SC16IS7XX_I2C static int sc16is7xx_i2c_probe(struct i2c_client *i2c, const struct i2c_device_id *id) { @@ -1253,8 +1321,43 @@ static struct i2c_driver sc16is7xx_i2c_uart_driver = { .remove = sc16is7xx_i2c_remove, .id_table = sc16is7xx_i2c_id_table, }; -module_i2c_driver(sc16is7xx_i2c_uart_driver); + MODULE_ALIAS("i2c:sc16is7xx"); +#endif + +static int __init sc16is7xx_init(void) +{ + int ret = 0; +#ifdef CONFIG_SERIAL_SC16IS7XX_I2C + ret = i2c_add_driver(&sc16is7xx_i2c_uart_driver); + if (ret < 0) { + pr_err("failed to init sc16is7xx i2c --> %d\n", ret); + return ret; + } +#endif + +#ifdef CONFIG_SERIAL_SC16IS7XX_SPI + ret = spi_register_driver(&sc16is7xx_spi_uart_driver); + if (ret < 0) { + pr_err("failed to init sc16is7xx spi --> %d\n", ret); + return ret; + } +#endif + return ret; +} +module_init(sc16is7xx_init); + +static void __exit sc16is7xx_exit(void) +{ +#ifdef CONFIG_SERIAL_SC16IS7XX_I2C + i2c_del_driver(&sc16is7xx_i2c_uart_driver); +#endif + +#ifdef CONFIG_SERIAL_SC16IS7XX_SPI + spi_unregister_driver(&sc16is7xx_spi_uart_driver); +#endif +} +module_exit(sc16is7xx_exit); MODULE_LICENSE("GPL"); MODULE_AUTHOR("Jon Ringle ");