atl1e: convert to net_device_ops

Convert this driver to network device ops. Compile tested only.

Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
This commit is contained in:
Stephen Hemminger 2008-11-19 22:12:06 -08:00 committed by David S. Miller
parent 758e43b74c
commit 1e058ab58f

View File

@ -2253,26 +2253,32 @@ static void atl1e_shutdown(struct pci_dev *pdev)
atl1e_suspend(pdev, PMSG_SUSPEND);
}
static const struct net_device_ops atl1e_netdev_ops = {
.ndo_open = atl1e_open,
.ndo_stop = atl1e_close,
.ndo_get_stats = atl1e_get_stats,
.ndo_set_multicast_list = atl1e_set_multi,
.ndo_validate_addr = eth_validate_addr,
.ndo_set_mac_address = atl1e_set_mac_addr,
.ndo_change_mtu = atl1e_change_mtu,
.ndo_do_ioctl = atl1e_ioctl,
.ndo_tx_timeout = atl1e_tx_timeout,
.ndo_vlan_rx_register = atl1e_vlan_rx_register,
#ifdef CONFIG_NET_POLL_CONTROLLER
.ndo_poll_controller = atl1e_netpoll,
#endif
};
static int atl1e_init_netdev(struct net_device *netdev, struct pci_dev *pdev)
{
SET_NETDEV_DEV(netdev, &pdev->dev);
pci_set_drvdata(pdev, netdev);
netdev->irq = pdev->irq;
netdev->open = &atl1e_open;
netdev->stop = &atl1e_close;
netdev->hard_start_xmit = &atl1e_xmit_frame;
netdev->get_stats = &atl1e_get_stats;
netdev->set_multicast_list = &atl1e_set_multi;
netdev->set_mac_address = &atl1e_set_mac_addr;
netdev->change_mtu = &atl1e_change_mtu;
netdev->do_ioctl = &atl1e_ioctl;
netdev->tx_timeout = &atl1e_tx_timeout;
netdev->netdev_ops = &atl1e_netdev_ops;
netdev->hard_start_xmit = atl1e_xmit_frame,
netdev->watchdog_timeo = AT_TX_WATCHDOG;
netdev->vlan_rx_register = atl1e_vlan_rx_register;
#ifdef CONFIG_NET_POLL_CONTROLLER
netdev->poll_controller = atl1e_netpoll;
#endif
atl1e_set_ethtool_ops(netdev);
netdev->features = NETIF_F_SG | NETIF_F_HW_CSUM |