sh-sci / PM: Avoid deadlocking runtime PM

The runtime PM of sh-sci devices is enabled when sci_probe() returns,
so the pm_runtime_put_sync() executed by driver_probe_device()
attempts to suspend the device.  Then, in some situations, a
diagnostic message is printed to the console by one of the runtime
suspend routines handling the sh-sci device, which causes synchronous
runtime resume to be started from the device's own runtime suspend
callback.  This causes rpm_resume() to be run eventually, which sees
the RPM_SUSPENDING status set by rpm_suspend() and waits for it to
change.  However, the device's runtime PM status cannot change at
that point, because the routine that has set it waits for the
rpm_suspend() to return.  A deadlock occurs as a result.

To avoid that make sci_init_single() increment the device's
runtime PM usage counter, so that it cannot be suspended by
driver_probe_device().  That counter has to be decremented
eventually, so make sci_startup() do that before starting to
actually use the device and make sci_shutdown() increment it
again before returning to balance the incrementation carried out by
sci_startup().

Signed-off-by: Rafael J. Wysocki <rjw@sisk.pl>
Tested-by: Kuninori Morimoto <kuninori.morimoto.gx@renesas.com>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
This commit is contained in:
Rafael J. Wysocki 2012-03-09 12:59:44 +09:00 committed by Paul Mundt
parent 948c46a195
commit 048be431e4

View File

@ -1710,6 +1710,8 @@ static int sci_startup(struct uart_port *port)
dev_dbg(port->dev, "%s(%d)\n", __func__, port->line);
pm_runtime_put_noidle(port->dev);
sci_port_enable(s);
ret = sci_request_irq(s);
@ -1737,6 +1739,8 @@ static void sci_shutdown(struct uart_port *port)
sci_free_irq(s);
sci_port_disable(s);
pm_runtime_get_noresume(port->dev);
}
static unsigned int sci_scbrr_calc(unsigned int algo_id, unsigned int bps,
@ -2075,6 +2079,7 @@ static int __devinit sci_init_single(struct platform_device *dev,
sci_init_gpios(sci_port);
pm_runtime_irq_safe(&dev->dev);
pm_runtime_get_noresume(&dev->dev);
pm_runtime_enable(&dev->dev);
}